Idiomas disponibles
Idiomas disponibles
Levding
the Washer
Yourwasher has 4 levding legs that are Jocatd on the 4 bottom corners_ After
properly placing your washer in its final location, you may levd the washer.
'p Leveling legs can be adiustd
by turning them counter-clockwise to raise the
washer and clockwise to lower the washer.
Note: Hf t he machine is slanting more than 2 ° it will notwork.
Installing
Your Washer
Readthe installation instructionscarefully before beginning_
1. Connectthe hot and cdd water inlet hosesto the hot and cold water faucet.
2. Connect the other ends to their respective washer inlets located at the top rear of
the machine. Connect the red tinted hose fitting to the washer and the other end
to the incoming water supply.
3_ Installthe drain hoseto the side of the washer usingdrain hoseclamp_Thedrain
hosemustbe placed into a drainpipe or sink at least 1-1/2 inches in diameten
Usethe gooseneckdrain hook to hold hosein pJace_ Toavoid possiblewater
back up, thedrain hosemustreach a height of at least 31-1/2 inchesminimum
and 40 inches maximum.
4_ Plug in the Washer to a regdar 115 Volt / 60 Hz, 15 Amps outlet.
Not÷:
Carefully inspect for any leaks around and back of the machine. If
there is a leak, turn off the unit and unplug it, then check if any
connections are loose. You may need to tighten any loose
connections_
CAUTION: if after completingthesestepsyou are still unsureif unit has been
properly installed,contact a qualified instaJJen \ 'Ve recommendthat the
washer be installedby a certified technicianto ensurethat it is
properly installed.
installing
inner Plato
A. Open the top lid of the washing machine.
B. install the inner plate on the outer tub by"aligning the plate shaftsto the tub cover
groves,
C. To install, insert on one side first and then snap in on the other side.
Note: Do Not
use washer
without installing
the
inner plate.
] 8
