Idiomas disponibles
Idiomas disponibles
FIRST USE
1.
Place the Bean Hopper onto the machine and rotate the knob clockwise until it clicks into
place. Add whole coffee beans. Place the Bean Hopper lid onto the Bean Hopper.
2.
Fill the Water Tank with fresh water. Place the Water Tank lid.
IMPORTANT: Distilled water or mineral water can damage the Semi-Automatic Espresso
Machine. Do not use either to brew Espresso.
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
3.
Plug into a grounded 3 prong outlet. Press the Main Power Button to the ON position.
4.
The machine automatically pumps water into the heater and starts heating. When the
heating light stops blinking, the machine is ready for use.
5.
Rinse the Group Head, place a container under the Group Head. Toggle the Mode Button
to select Espresso mode. Toggle Dose Button to 1 and press the
Brew Start/Stop Button (
automatically stop when the cycle is complete.
NOTE: If water does not come through in the first use see "Troubleshooting" section in
online "Product Guide."
6.
To rinse the Steam Wand, direct the Steam Wand towards the Drip Tray or into a cup.
Then, toggle the Mode Button to select Steam mode and press the
Brew Start/Stop Button (
the Brew Start/Stop Button (
START UP CHECKLIST
■ Soak Water Filter for 5 minutes before inserting into the Water Filter Holder.
■ Install Water Filter and fill Water Tank.
■ Secure Water Tank.
■ Add beans and secure the Bean Hopper to the grinder. If it is not properly secured, the
power light will flash.
■ Plug in the power cord.
■ Turn the machine ON, the water pump will start working and the water will begin to heat up.
■ When heating is done, the temperature light will stop flashing.
NOTE: If the Hot Water Mode Button light blinks, refer to the QR code or the
"Priming Pump Instructions" section.
WARNING
Electrical Shock Hazard
). The machine will flush water through the Group Head and
) to start. Allow water to flow for 3 to 5 seconds then, press
) to stop.
7
