Idiomas disponibles
Idiomas disponibles
CONTROL PANEL
4
3
1. Grind Start/Stop Button
2. Grind Amount Select Knob
3. Heating Light Indicator
4. Power Button
5. Mode Button
■ Espresso
■ Steam
■ Hot Water
PRIMING PUMP INSTRUCTIONS
Recommended for first time use and if the Semi-Automatic Espresso Machine has not been
used for long periods of time.
Remove and discard the red plastic seal used for shipping, located at the Water Tank base.
NOTE: The Priming Pump is a clear plastic injector that can be found inside the accessory
box.
1.
Press the Priming Pump.
2.
Dip the tip of the Priming Pump in a reservoir of water to fill it.
3.
Hold the Priming Pump in the vertical position.
4.
Remove the Water Tank and insert the Priming Pump in the Water Tank connector.
5.
With the machine plugged in but powered off, press and hold the Temperature Button for
3 seconds until the Power Button ( ), Heating Light Indicator, Espresso, Steam, and
Hot Water mode setting lights turn ON.
6.
Place a container under the Group Head. Press the Brew Start/Stop Button (
the priming operation, when the machine begins working, press the Priming Pump until
water comes out from the Group Head or Water Spout. If necessary, fill up the pump again
and repeat steps, turning off the machine in the meantime.
CONDITIONING THE WATER FILTER
Remove the Water Filter and Water Filter Holder from the plastic bag.
1.
Soak Water Filter for 5 minutes.
2.
Rinse Water Filter.
3.
Place Water Filter into Water Filter Holder.
4.
Set date slider 2 months ahead.
5.
Install Water Filter in Water Tank.
6.
Place and secure the Water Tank.
6
2
1
5
6
10
9
6. Dose Button
■ 1 (1 Shot)
■ 2 (2 Shot)
7. Pressure Gauge
8. Brew Start/Stop Button
9. Clean Cycle Button
10. Temperature Button
■ Low
■ Medium
■ High
7
8
) to start
