Idiomas disponibles
Idiomas disponibles
STEAM
1.
Toggle the Mode Button to select Steam mode for heating and frothing the milk. The
machine will start heating if not already heated, indicated by the flashing heating light. The
heating light will go solid when machine is ready for steaming.
2.
Fill between 1/3 and 1/2 volume of the Milk Pitcher with milk to allow for frothing
expansion.
3.
Purging 1: Angle the Steam Wand toward the Drip Tray to purge any water condensed
inside the Steam Wand. Press the Brew Start/Stop Button (
1 second and stop by pressing the Brew Start/Stop Button (
4.
Frothing: Submerge the tip of the Steam Wand just below the surface of milk in the
Milk Pitcher. Press the Brew Start/Stop Button (
desired level of foam and temperature is reached. To stop the steam, press the
Brew Start/Stop Button (
removing the Steam Wand from the milk.
NOTE: You can use the Steam Wand to preheat cups and Filter Baskets.
5.
Heating: Submerge the Steam Wand deeper in the Milk Pitcher. Press the
Brew Start/Stop Button (
too hot to touch. To stop the steam, press the Brew Start/Stop Button (
6.
Purging 2: Angle the Steam Wand toward the Drip Tray to purge any water condensed
inside the Steam Wand. Press the Brew Start/Stop Button (
2 to 3 seconds and stop by pressing the Brew Start/Stop Button (
Tips and Recommendations
TIP: Immediately after use, wipe the Steam Wand and purge it by turning it towards the
Drip Tray and letting steam run for 2 to 3 seconds.
TIP: When frothing, submerge the tip of the Steam Wand just below the surface of milk and
position until a smooth hissing sound is heard. To just heat the milk, submerge the
Steam Wand into the milk. To avoid overheating the milk, stop steaming when the Milk Pitcher
is hot to touch.
HOT WATER
1.
Toggle the Mode Button to select Hot Water mode. Place a cup under the Water Spout.
NOTE: Position your cup with consideration that the Water Spout is angled towards the
Group Head.
2.
Press Dose Button to select the volume of water 1 (~ 5.5 oz/~ 163 ml) or
2 (~ 7 oz/~ 207 ml). Press the Brew Start/Stop Button (
Personalize Hot Water
Water dose: To use less than the default water doses, you can pause the cycle by pressing
the Brew Start/Stop Button (
complete.
To change pre-programmed water volume for 1 or 2: Toggle the Mode Button to select Hot
Water mode. Select the dose you desire to program (1 or 2). Press and hold
Brew Start/Stop Button (
programing your selected dose, the dose and the Brew Start/Stop Button (
blink. Lights will stop blinking when programming is complete.
TIP: To restore all factory settings, press and hold Dose Button for 3 seconds. All indicator
lights will blink indicating that all settings are restored.
10
) again. To avoid splattering, wait until the steam stops before
) to initiate the steam. Heat until the Milk Pitcher is
) at any time to stop the flow of water before the cycle
) until the desired water amount is reached in your cup. While
) to run a steam cycle for
).
) to initiate the steam. Froth until
) to run a steam cycle for
).
) to start hot water cycle.
) again.
) lights will
