Idiomas disponibles
Idiomas disponibles
3.
Use the Mode Button to toggle and select the desired water hardness level.
4.
The selected water hardness will be indicated by the machine as follows:
Low hardness: Espresso mode LED indicator will turn ON.
Medium hardness: Espresso and Steam mode LED indicators will turn ON.
High hardness: Espresso, Steam, and Hot Water mode LED indicators will turn ON.
5.
After selecting the water hardness, press the Brew Start/Stop Button (
choice. The Brew Start/Stop Button (
will begin heating up.
DESCALING THE SEMI-AUTOMATIC ESPRESSO MACHINE
The descaling program enables simple and effective descaling of your Semi-Automatic
Espresso Machine. Descale the Semi-Automatic Espresso Machine regularly, but a minimum
whenever the Clean Cycle Button (
the hardness of the water in your region.
NOTE: The descaling process runs in 2 phases, takes approximately 2 minutes for each phase
and must be completed before next use. At any time during the descaling program you can
pause the cycle by pressing the Brew Start/Stop Button (
again.
IMPORTANT: Only use descaling solutions intended for Semi-Automatic Espresso Machines.
SET UP DESCALING
1.
Remove the Water Filter and fill the Water Tank to the 2.5 L mark. Add the descaling
solution and follow the instructions provided on the package for the correct ratio.
2.
When the power and heating LEDs are ON, press and hold the Clean Cycle Button (
3 seconds. The Clean Cycle Button (
Brew Start/Stop Button (
3.
Phase 1 (Cleaning): Place two containers (~ 30 oz/~ 887 ml each) to collect water, one
under the Group Head and Water Spout, and another under the Steam Wand. Press the
Brew Start/Stop Button (
NOTE: The descaling process will run continuously, first dispensing water through the
Group Head, then the Water Spout, and finally through the Steam Wand.
4.
Once the cleaning cycle is complete, unit will start preheating, and the heating LED will
blink. When preheating is complete, the heating LED will stay ON, and the
Clean Cycle Button (
cleaning cycle.
IMPORTANT: Before starting Phase 2, empty, rinse, and thoroughly clean the Water Tank.
5.
Phase 2 (Rinsing): Fill the Water Tank to the 2.5 L mark, replace the Water Filter and
reinstall the Water Tank on the machine.
Place the same two containers under the Group Head and Steam Wand. Press and hold
the Clean Cycle Button (
solid. The Brew Start/Stop Button (
Brew Start/Stop Button (
NOTE: The rinse cycle will behave like the cleaning cycle; water will continuously
dispense from the Group Head, Water Spout, and Steam Wand.
6.
When the second rinse cycle is complete, both Brew Start/Stop Button (
Clean Cycle Button (
and enjoy making an Espresso.
NOTE: In case of any interruptions (for example low water level or power outage), the
cleaning cycle will reset and start from the beginning of the descaling cycle.
) LED indicator will blink once, and the machine
) light is blinking. The frequency of descaling depends on
) LED will stay ON and the
) LED will flash.
) to begin the cleaning cycle.
) LED will blink, indicating it is ready to start the next phase of the
) for 3 seconds until the Clean Cycle Button (
) LED will flash. Press the
) to initiate the rinse cycle.
) LEDs will blink simultaneously. Press any button to exit the cycle
) to confirm your
). And, resume too by pressing it
) LED light stays
) and
) for
13
