Idiomas disponibles
Idiomas disponibles
AC motor:
• The mains voltage must be 230 - 240 V~.
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
11. Cleaning
m
Warning! Prior to any adjustment, maintenance or
service work disconnect the mains power plug!
General maintenance measures
Wipe chips and dust off the machine from time to time
using a cloth. In order to extend the service life of the
tool, oil the rotary parts once monthly. Do not oil the
motor.
When cleaning the plastic do not use corrosive prod-
ucts.
The threaded spindle for height-adjustment of the
thicknessing table may only be treated with a dry lu-
bricant agent.
The table surfaces as well as the infeed and output roll-
ers must always be kept free from resin.
Regularly clean infeed and output rollers.
In order to avoid overheating of the motor, regularly
check the air openings for any dust sticking on.
After a longer period of use, it is recommended to have
the machine checked by an authorized dealer service
Tool care:
Cutter block, clamping devices, knife supports and
knives must be regularly cleaned from resin, as a clean
tool improves the planing quality. To this purpose,
clamping devices, knife supports and knives can be
put in a common resin remover for 24 hours.
Resin from aluminium tools may only be removed with
cleaning liquids not being aggressive to this type of
metal.
34 | GB
.
2
www.scheppach.com
12. Storage
Store the device and its accessories in a dark, dry and
frost-proof place that is inaccessible to children. The op-
timum storage temperature is between 5 and 30˚C. Store
the electrical tool in its original packaging. Cover the
electrical tool in order to protect it from dust and mois-
ture. Store the operating manual with the electrical tool.
13. Maintenance
Warning!
Prior to any adjustment, maintenance or service work
disconnect the mains power plug!
Changing the knives (Fig 17-19)
•
m Important!: Always pull the mains plug before
changing the knives.
• Pull the planing knife cover (9) forwards as far as
possible so that the entire knife block is exposed.
• Loosen and remove the four clamping screws (23).
• Lift the knives (25) and knife block (24) from the cut-
ter block.
• Remove the chips and any resin from the cutter
block and knife support.
• Place new knives (25) into the cutter block and fix
them with the rectangle slots in both screw heads.
(With these two screws, height-adjustment of the
knife is done.)
• Place the knife block (24) onto the knife.
• Slightly tighten the four clamping bolts (23).
• Repeat these actions for the second knife.
• Place the blade adjustment block (18), as shown
in Figure 18, on the knife block. Make sure that the
knife (25) touches both sides of the blade adjust-
ment block (18).
• By the two set screws (26), the knife can be adjusted
for height.
• After a successful knife setting, all clamping screws
must be tightened
Please mind:
• Sharp planer/thicknesser knives guarantee a clean
planing surface and put less stress on the motor.
• After three grinding actions, a maximum material re-
moval of 3 x 0.05 mm may not be exceeded.
• The planer/thicknesser blades used on this machine
are not suitable for rebating and dovetailing.
• Finally lower the cutter block guard again onto the
table. Cover the cutter block and block it with the
star grip screw.
