Kenmore 106.6110 Serie Manual De Uso Y Cuidado página 19

Refrigerador con congelador en la parte superior
Idiomas disponibles

Idiomas disponibles

....
Comp s ,
C,,sddy
To remove and replace the utility compartment.,
1. Remove the utility compartment
by raising and holding the
cover up while lifting the utility compartment
up and pulling
it straight out.
2. Replace the utility compartment
by sliding it in above the
desired support and pushing it down until it stops.
To remove and replace the can caddy=
1.
2.
3.
Hold the can caddy with one hand and pull up until it is
released from the door liner. Then, pull up on the caddy
again, until the stoppers have been overcome.
Pull the can caddy straight out to remove it from the door.
Replace the can caddy by aligning
the grooves on the sides
with the pins in the door liner. Push up on the bottom of the
caddy until the stoppers have been overcome, and slide it
fully into the compartment.
REFRIGERATOR CARE
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
IMPORTANT= Because air circulates between both sections, any
odors formed in one section will transfer to the other. You must
thoroughly clean both sections to eliminate odors. To avoid odor
transfer and drying out of food, wrap or cover foods tightly.
To Clean Your Refrigerator=
NOTE= Do not use abrasive or harsh cleaners such as window
sprays, scouring cleansers, flammable
fluids, cleaning waxes,
concentrated detergents,
bleaches or cleansers containing
petroleum
products on plastic parts, interior and door liners or
gaskets. Do not use paper towels, scouring pads, or other harsh
cleaning materials.
1. Unplug refrigerator
or disconnect power.
2. Hand wash, rinse, and dry removable
parts and interior
surfaces thoroughly.
Use a clean sponge or soft cloth and a
mild detergent
in warm water.
3. Wash stainless steel and painted metal exteriors with a
clean sponge or soft cloth and a mild detergent in warm
water. Dry thoroughly
with a soft cloth.
NOTE= To keep your stainless steel refrigerator
looking like
new and to remove minor scuffs or marks, it is suggested
that you use the manufacturer's
approved
Stainless Steel
Cleaner and Polish. To order the cleaner, see the
"Accessories" s ection.
IMPORTANT: This cleaner is for stainless steel parts only!
Do not allow the Stainless Steel Cleaner and Polish to come
into contact with any plastic parts such as the trim pieces,
dispenser covers or door gaskets. If unintentional
contact
does occur, clean plastic part with a sponge and mild
detergent in warm water. Dry thoroughly
with a soft cloth.
4.
Plug in refrigerator
or reconnect
power.
NOTE= Not all appliance
bulbs will fit your refrigerator.
Be sure
to replace the bulb with an appliance
bulb of the same size,
shape, and wattage
(no greater than 40 watts).
Style 1 - Electronic Control
The light bulbs are located at the top of the refrigerator
compartment.
1. Unplug refrigerator
or disconnect power.
2. Using both hands, squeeze inward on the sides of the light
shield, releasing it from the back of the compartment.
Then,
move the shield toward the back to release it from the front
of the compartment.
3. Remove the light bulb(s) and replace it with a 40 watt
appliance
bulb of the same size and shape.
Both the refrigerator
and freezer sections defrost automatically.
However, clean both sections about once a month to keep odors
from building up. Wipe up spills immediately.
19
loading