Idiomas disponibles
Idiomas disponibles
IMPORTANT: To comply with American Disabilities Act (ADA)
guidelines, fully retract the rollers into the cabinet to lower the
refrigerator.
Door Closing
Your refrigerator
has two front adjustable
rollers - one on the
right and one on the left. If your refrigerator
seems unsteady or
you want the doors to close easier, adjust the refrigerator's
tilt
using the following
instructions:
1.
2.
Remove the base grille. See the Base Grille graphic
in
"Refrigerator
Doors." The two leveling screws are part of the
front roller assemblies, which are at the base of the
refrigerator
on either side.
Use a socket driver to adjust the leveling screws. Turn the
leveling screw to the right to raise that side of the
refrigerator
or turn the leveling screw to the left to lower
that side. It may take several turns of the leveling screws to
adjust the tilt of the refrigerator.
NOTE: Having someone push against the top of the
refrigerator
takes some weight off the leveling screws and
rollers which makes it easier to adjust.
.
J
Open both doors again to make sure they close as easily as
you like and that they stay closed. If not, tilt the refrigerator
slightly more to the rear by turning both leveling screws to
the right. It may take several more turns.
NOTES:
•
To keep the refrigerator
level, you should turn both
leveling screws the same amount.
•
On models with the leveling/roller
assembly, after
adjusting the refrigerator
to the desired tilt, turn the
leveling leg until it is firmly against the floor as shown.
On some models
A. Bottom
hinge
C. Leveling/roller
B.Screws
assembly
4.
Replace
the base grille.
Door Aligning
If the space between your doors looks uneven, you can adjust it
using the following
instructions:
1. Pry off the top hinge cover.
2. Loosen the top hinge screws using a 5A6" socket or wrench.
3. Have someone hold the door in place or put a spacer
between the doors while you tighten the top hinge screws.
4. Replace the top hinge cover.
Your new refrigerator
may make sounds that your old one didn't
make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal.
Hard surfaces, such as the floor, walls, and cabinets, can make
the sounds seem louder. The following
describes the kinds of
sounds and what may be making them.
•
If your refrigerator
is equipped with an ice maker, you will
hear a buzzing sound when the water valve opens to fill the
ice maker for each cycle.
Your refrigerator
is designed to run more efficiently to keep
your food items at the desired temperatures
and to minimize
energy usage. The high efficiency compressor and fans may
cause your refrigerator
to run longer than your old one. You
may also hear a pulsating or high-pitched
sound from the
compressor or fans adjusting to optimize performance.
You may hear the evaporator fan motor circulating
air
through the refrigerator
and freezer compartments.
The fan
speed may increase as you open the doors or add warm
food.
Rattling noises may come from the flow of refrigerant,
the
water line, or items stored on top of the refrigerator.
Water
dripping on the defrost heater during a defrost cycle
may cause a sizzling sound.
As each cycle ends, you may hear a gurgling
sound due to
the refrigerant
flowing in your refrigerator.
Contraction
and expansion of the inside walls may cause a
popping
noise.
You may hear air being forced over the condenser by the
condenser fan.
•
You may hear water running into the drain pan during the
defrost cycle.
13
