Idiomas disponibles
Idiomas disponibles
Safety
Important Safety Instructions
SAVE THESE INSTRUCTIONS - This manual
contains important instructions that should be
followed during installation, operation, and
maintenance of the product.
This is the safety alert symbol. When you
see this symbol on your pump or in this manual,
look for one of the following signal words and
be alert to the potential for personal injury!
indicates a hazard which, if not
avoided, will result in death or serious injury.
indicates a hazard which, if not
avoided, could result in death or serious injury.
indicates a hazard which, if not
avoided, could result in minor or moderate injury.
NOTICE addresses practices not related to
personal injury.
Carefully read and follow all safety instructions
in this manual and on pump.
Keep safety labels in good condition. Replace
missing or damaged safety labels.
General Safety Information
Before you start first, refer to local codes to
ensure safety and regulatory compliance. This
sump pump should give years of trouble-free
service when correctly installed, maintained,
and used. However, interruption of power to
the pump, dirt/debris in the sump, flooding
that exceeds the pump's capacity, electrical
or mechanical failure in the pump, etc., may
prevent normal pump operation. To help prevent
damage from flooding, purchase a secondary
AC sump pump, a DC backup sump pump,
and/or a high water alarm. See Troubleshooting
in this manual for information about common
sump pump problems and remedies. For more
information, call customer service at 1-888-987-
8677 or visit our website at femyers.com.
Attention: This owner's manual contains
important information for the safe use of this
product. Read this manual completely before
using this product and refer to it often for
continued safe product use. DO NOT THROW
AWAY OR LOSE THIS MANUAL. Keep it in a
safe place so that you may refer to it often.
Risk of electric shock. Before
handling these pumps and controls, always
disconnect the power first. Do not smoke or
use spark-able electrical devices or flames in
a septic (gaseous). Can shock, burn or kill. To
reduce the risk of hazardous or fatal electrical
shock, follow instructions A through D, below:
A. This pump has an approved 3-conductor
power cord with 3-prong, grounding-type plug.
Connect the pump only to a properly grounded,
3-prong outlet. If the sump pump circuit has
a 2-prong outlet, replace it with a grounded
3-prong outlet installed according to code.
For parts or assistance, call Customer Service at 1-888-987-8677
B. Unplug the pump before handling or servicing
it. If your basement floor is wet, turn off all
power before walking on it. If the shut-off box
is in the basement, call your electric company
or hydro authority to shut off service to the
house, or call your local fire department
for instructions. After turning off the power,
remove the pump for service.
C. Protect the electrical cords from sharp objects,
hot surfaces, oil, and chemicals. Avoid kinking
the cords. Replace damaged or worn cords.
D. Do not lift the pump by the power cord.
Risk of fire. Plastic pipe glue
is extremely flammable. Follow the glue
manufacturer's instructions when assembling
glued plastic pipe.
Risk of burns. Motors may run hot.
Allow 20 minutes to cool before handling.
1. Know the pump application, limitations, and
potential hazards.
2. Do not use this pump in water with fish
present. If any oil leaks out of the motor it can
kill fish.
3. Drain the system completely before servicing it.
4. To prevent a flexible discharge line from
whipping, which could cause injury or
damage, fasten it down before starting
the pump.
5. Before each use, check any hoses in the system
for weakness or wear. Make certain that all
connections are tight.
6. Periodically inspect the sump, the pump,
and the piping for debris and foreign objects.
Perform routine cleaning as required.
7. Personal Safety:
a. Wear safety glasses at all times when
working with pumps.
b. Keep your work area clean, uncluttered
and properly lighted; put away all unused
tools and equipment.
c. Keep visitors at a safe distance from the
work area.
d. Make workshop child-proof with padlocks
and master switches. Remove any
starter keys.
8. This pump installation must meet all applicable
laws, codes, and ordinances.
California Proposition 65 Warning
This product and related accessories
contain chemicals known to the State of California to
cause cancer, birth defects or other reproductive harm.
Specifications
Power supply .......... 115V, 60 HZ., 15 Amp Circuit
Liquid Temp. Range ..............32°F to 70°F(0°-21°C)
Individual Branch Circuit Required (min.) 15 Amps
Discharge: ................................ 1-1/2" Female NPT
2
