Webasto Cool Top Trail 36V Instrucciones De Uso Y De Instalacion página 5

3 Scope of delivery
The system will be delivered in 2 packages.
Please check the delivery for completeness and damage.
Fig. 1 Outdoor unit
Pos. Description
1 Outdoor unit
2 Air inlet duct
3 Operating- and Installation instructions
4 Template for the outdoor unit
Fig. 2 Indoor unit
Pos. Description
1 Adaptor frame
2 Air distributor mounting bracket
9044618A_OI-II_Cool Top Trail 36V
Pos. Description
3 Air distributor
(LED lights optional)
4 Return air filter
5 M8 x 120 mm hex head bolt
6 Metal clamping bar
7 Large M8 washer
8 Air distributor pan head screw
ST4.2*19
9 Countersunk head self-tapping screw
ST4.2*16-C
10 Remote control with holder and batteries
(2 x size AAA)
11 Template for the indoor unit
4
4.1
l Thoroughly read and understand this manual before install-
Quantity
ation.
1
l Do not add any other parts or modify the product in the in-
1
stallation.
1
l Consult Webasto or the local distributor in case of unusual
1
applications or installation conditions that are not specific-
ally covered by this manual.
WARNING
If a heater exhaust pipe is mounted through the roof
nearby the A/C unit, then the exhaust pipe must be ex-
tended 10 cm above the A/C unit.
1
4.2
l The vehicle roof must be able to support the weight of the
2
air conditioner.
l The minimum thickness of roof is 25 mm; the maximum
thickness of roof is 70 mm.
l The roof must be level and smooth.
3
4.3
4
The installation is possible for different cut-out sizes.
5
6
To install a 400 x 400 mm roof hatch:
7
1. Dismount the roof hatch and use the remaining cut-out.
8
9
2. Remove sealant residue and unevenness.
10
3. Fill in the screw holes with flexible non-hardening butyl
body sealant.
4. The adapter frame for 400 x 400 mm cut-outs is part of the
11
scope of delivery.
To install a 360 x 360 mm roof hatch:
1. Dismount the roof hatch and use the remaining cut-out.
Either you have purchased a unit with a 360 x 360 adapter
or you must buy the optional adaptor frame for such cut-
outs. You can use it instead of the 400 x 400 mm adaptor
frame.
Quantity
2. Remove sealant residue and unevenness.
1
3. Fill in screw holes with flexible non-hardening butyl body
1
sealant.
Installation instructions
General
Installation requirements
Different cut-out sizes
Scope of delivery | 3
Quantity
1
1
4
4
4
4
10
1
1
5 / 154