Idiomas disponibles
Idiomas disponibles
7
Cutting Height Adjustment
The cutting height adjust pedal adjusts the mower cutting
height. See Specifications for cutting height adjustment
range.
To adjust cutting height:
1.
Fully press the cutting height adjustment pedal (A, Figure
8) until the transport release rod (B) locks the deck into
the highest position (transport position).
2.
Remove the pin (C, Figure 8) from the adjustment
bracket, and install it in the desired hole.
NOTICE
Make sure that the pin is installed into the holes in both upper
and lower plates of the adjustment bracket.
8
3.
Press the cutting height adjustment pedal, move the
transport release rod outward, and slowly release the
pedal until it rests against the pin.
8
Operating Area
1.
Know the area where you will operate the mower.
2.
Make sure that the area is free of unwanted material that
the blades could pick up and throw.
DANGER
This machine can throw objects that could cause injury to
bystanders or damage to buildings.
•
Do not operate the machine without the entire grass
catcher, discharge chute, or other safety devices in place
and operating correctly. Check frequently for signs of
wear or deterioration and replace as needed.
•
Clear the operating area of any objects which could be
thrown by or cause interference to the operation of the
machine.
ferrismowers.com
