JBM 52596 Manual De Instrucciones página 5

REF. 52596/52597
2. Once the nut is loosened, remove it. Remove the
threaded rod attached to it. To do this, pull and
hold back the retractable ring that holds the nut.
vástago roscado que tiene puesto.
Retractable ring
3. To replace the fitting, turn the threaded rod coun-
ter clockwise and remove it.
4. Then press the retractable ring down again and
hold it, insert the threaded rod you want to use,
screw it in until it stops and insert the correspon-
ding nut.
TROUBLESHOOTING
If the riveting process is not well done, the riveting
tool will not be easy to remove. If you cannot extract it
easily, do not use force, you may damage the tool.
Solution: Insert an L wrench into the hole as shown
in the picture. Turn it, then the tool can be easily
extracted.
NOTE: You may choose another type of wrench or
tool, as long as it fits the hole dimensions on the riveter.
· 5 ·