Idiomas disponibles
Idiomas disponibles
INSTALLATION
SELECTION OF INSTALLATION EQUIPMENT
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the
hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant and
insulated work surface material (Wood and similar fibrous or hygroscopic material shall not be used
as work surface material unless impregnated) to avoid the electrical shock and larger deformation
caused by the heat radiation from the hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces of the
worktop should be at least 3mm.
L(mm) W(mm) H(mm) D(mm) A(mm)
590
520
Under any circumstances, make sure the Induction cooker hob is well ventilated and the air inlet
and outlet are not blocked. Ensure the induction cooker hob is in good work state. As shown below.
Note: The safety distance between the hotplate and the cupboard above the hotplate should
be at least 760 mm.
A(mm)
760
62
58
B(mm)
C(mm)
50 min.
20 min.
B(mm)
560+4+1
490+4+1 50 min.
D
Air intake
79
X(mm)
F(mm)
3 min.
E
Air exit 5mm
