Kenmore 795.7160 Manual De Uso Y Cuidado página 31

Congelador inferior refrigerador
Ocultar thumbs Ver también para 795.7160:
Idiomas disponibles

Idiomas disponibles

UNDERSTANDING
SOUNDS
YOU MAY HEAR
Your new refrigerator
may make sounds that your old
one did not make. Because
the sounds
are new to
you, you might be concerned
about them. Most of
the new sounds
are normal.
Hard surfaces,
like the
floor, walls and cabinets,
can make the sounds seem
louder than they actually
are. The following
list
describes
the kinds of sounds
and what may be
making them.
• A clicking
noise may come from the electronic
control switching
the cooling
system
on and off.
• Rattling
noises may come from the flow of
refrigerant,
the water line, or items stored on top of
the refrigerator.
• Your refrigerator
is designed
to run more efficiently
to keep your food items at the desired
temperature.
The high efficiency
compressor
may cause your
new refrigerator
to run longer than your old one,
but is still more energy
efficient than previous
models.
While running,
you may hear a pulsating
or
high-pitched
sound, this is normal.
• You may hear the evaporator
fan motor circulating
the air through
the refrigerator
and freezer
compartments.
As each cycle ends, you may hear a gurgling
sound due to the refrigerant
flowing
in your
refrigerator.
• Contraction
and expansion
of the inside walls may
cause a popping
noise.
• Water dripping
on the defrost
heater during a
defrost cycle may cause a sizzling
sound.
• You may hear air being forced over the condenser
by the condenser
fan.
• You may hear water running
into the drain pan
during the defrost
cycle.
REFRIGERATOR
DOES
NOT OPERATE
Check if...
The power supply cord is unplugged.
A household fuse has blown or circuit breaker
tripped.
Refrigerator is in the defrost cycle.
Store sales floor Demonstration
Mode.
Then,..
Firmly plug the cord into a live outlet with proper voltage.
Replace the fuse or reset the circuit breaker. Check that the
house circuit is not overloaded.
Wait about 30 minutes for defrost cycle to end.
The refrigerator control has been put into the store Demo
(Demonstration)
Mode. The Demonstration Mode disables the
cooling system; only the interior lighting and the display will
work normally. To disable, open one door, then press Ultra Ice
and Refrigerator
Temp buttons at the same time for
5 seconds. You will see the previous temperature setting you
had on display when Demo Mode is deactivated.
31
loading