Idiomas disponibles
Idiomas disponibles
8. FLUSH OUT THE TUBING
Turn the main water supply on
and flush out the tubing until the
water is clear.
Shut the water off at the water
valve after about one quart of
water has been flushed through
the tubing.
10. TURN THE WATER ON AT THE
SHUTOFF
VALVE
Tighten
any connections
that leak.
9. CONNECT
THE TUBING
TO THE
REFRIGERATOR
NOTE:
Before
making the connection
to the
refrigerator,
be sure the refrigerator
power
cord is not plugged
into the wall outlet.
1. Remove
the plastic flexible
cap from the water
valve.
2. Place the compression
nut and ferrule
(sleeve)
onto the end of the tubing as shown.
3. Insert the end of the copper
tubing into the
connection
as far as possible.
While holding the
tubing, tighten the fitting.
_, CAUTION:
Check to see if leaks occur at water
line connections.
Tubing Cla_
1/4'mpression _,,_
L
_j,,_
j
1/4" Tubing
_
efrigerator
Connection
11. PLUG IN THE REFRIGERATOR
Arrange
the coil of tubing so that it does not
vibrate against the back of the refrigerator
or
against the wall. Push the refrigerator
back to
the wall.
12. START THE ICEMAKER
Set the icemaker
power switch to the On (I)
position.
NOTE:
A newly installed
refrigerator
may take
several
hours to start producing
ice.
CAUTION:
Check to see if water dripping
occurs
at water line connections.
30
