Idiomas disponibles
Idiomas disponibles
English
Owner´s manual
•
To restart the tool, switch off the tool first, remove the cause of sudden drop in the rotation speed, and
then turn the tool on.
Soft start feature
Soft start feature reduces starting reaction.
WARNINGS:
- It should never be necessary to force the tool. The weight of the tool applies adequate pressure. Forcing
and excessive pressure could cause dangerous wheel breakage.
- ALWAYS replace wheel if tool is dropped while grinding.
- NEVER bang or hit grinding disc or wheel onto work.
- Avoid bouncing and snagging the wheel, especially when working corners, sharp edges etc. This can
cause loss of control and kickback.
- NEVER use tool with wood cutting blades and other saw blades. Such blades when used on a grinder
frequently kick and cause loss of control leading to personal injury.
- Never switch on the tool when it is in contact with the workpiece, it may cause an injury to operator.
- Always wear safety goggles or a face shield during operation.
- After operation, always switch off the tool and wait until the wheel has come to a complete stop before
putting the tool down.
- ALWAYS hold the tool firmly with one hand on housing and the other on the side grip (handle).
Grinding and sanding operation
Turn the tool on and then apply the wheel or
disc to the workpiece.
In general, keep the edge of the wheel or disc at
an angle of about 15° to the workpiece surface.
During the break-in period with a new wheel,
do not work the grinder in forward direction or
it may cut into the workpiece. Once the edge
of the wheel has been rounded off by use, the
wheel may be worked in both forward and
backward direction.
Operation with abrasive cut-off / diamond wheel
Optional accessory
WARNING: Do not "jam" the wheel or apply excessive pressure. Do not attempt to make an excessive
depth of cut. Overstressing the wheel increases the loading and susceptibility to twisting or binding of
the wheel in the cut and the possibility of kickback, wheel breakage and overheating of the motor may
occur.
WARNING: Do not start the cutting operation in the workpiece. Let the wheel reach full speed and
carefully enter into the cut moving the tool forward over the workpiece surface. The wheel may bind, walk
up or kickback if the power tool is started in the workpiece.
43
