Goodyear GY 5020AG Manual De Instrucciones página 35

English
Owner´s manual
•
Installing or removing wheel guard
WARNING: When using a depressed center wheel, flap disc, flex wheel or wire wheel brush, the wheel
guard must be fitted on the tool so that the closed side of the guard always points toward the operator.
WARNING: Make sure that the wheel guard is
securely locked by the lock lever with one of the
holes on the wheel guard.
WARNING: When using an abrasive cut-off /
diamond wheel, be sure to use only the special
wheel guard designed for use with cut-off wheels.
(In some European countries, when using a
diamond wheel, the ordinary guard can be used.
Follow the regulations in your country.)
For depressed center wheel, flap disc, flex wheel,
wire wheel brush / abrasive cut-off wheel, dia-
mond wheel
1. While pushing the lock lever, mount the wheel
guard with the protrusions on the wheel guard
aligned with the notches on the bearing box
1. Lock lever 2. Notch 3. Protrusion
2. While pushing the lock lever toward A, push in
the wheel guard by holding down the portions B
as shown in the figure.
1. Wheel guard 2. Hole
NOTE: Push down the wheel guard straight.
Otherwise, you cannot push the wheel guard
completely.
1
B
A
3
2
B
1
2
35