Goodyear GY 5020AG Manual De Instrucciones página 41

English
Owner´s manual
•
To remove the battery cartridge, slide it from the tool while
sliding the button on the front of the cartridge. To install the
battery cartridge, align the tongue on the battery cartridge
with the groove in the housing and slip it into place. Insert it
all the way until it locks in place with a little click.
1. Red indicator 2. Button 3. Battery cartridge
CAUTION: Always install the battery cartridge fully until the red indicator cannot be seen. If not, it
may accidentally fall out of the tool, causing injury to you or someone around you.
CAUTION: Do not install the battery cartridge forcibly. If the cartridge does not slide in easily, it is not
being inserted correctly.
Charge indicator
Press the check button on the battery cartridge to indicate
the remaining battery capacity. The indicator lamps light up
for few seconds.
Lighted
NOTE: Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual
capacity.
Tool / battery protection system
The tool is equipped with a tool/battery protection system. This system automatically cuts off power to
the motor to extend tool and battery life. The tool will automatically stop during operation if the tool or
battery is placed under one of the following conditions:
Indicator lamps
Off
2
1
1
Remaining capacity
Blinking
Charge the battery
The battery may have
3
1. Indicator
lamps *
2. Check
2
button *
75% to 100%
50% to 75%
25% to 50%
0% to 25%
malfunctioned
41