Goodyear GY 5020AG Manual De Instrucciones página 36

English
Owner´s manual
•
3. While keeping the lock lever and wheel guard
position as described in step 2, rotate the wheel
guard toward C, and then, change the angle of
the wheel guard according to the work.
1. Wheel guard 2. Hole
NOTE: Push the wheel guard completely.
Otherwise, you cannot rotate the wheel guard.
To remove wheel guard, follow the installation
procedure in reverse.
Installing or removing depressed center wheel or flap disc
Optional accessory
WARNING: When using a depressed center wheel or flap disc, the wheel guard must be fitted on the
tool so that the closed side of the guard always points toward the operator.
CAUTION: Make sure that the mounting part of the inner flange fits into the inner diameter of the
depressed center wheel / flap disc perfectly. Mounting the inner flange on the wrong side may result in
the dangerous vibration.
Mount the inner flange onto the spindle. Make
sure to fit the dented part of the inner flange
onto the straight part at the bottom of the
spindle.
Fit the depressed center wheel / flap disc on the
inner flange and screw the lock nut onto the
spindle.
1. Lock nut 2. Depressed center wheel 3. Inner
flange 4. Mounting part
To tighten the lock nut, press the shaft lock
firmly so that the spindle cannot revolve, then
use the lock nut wrench and securely tighten
clockwise.
1. Lock nut wrench 2. Shaft lock
To remove the wheel, follow the installation
procedure in reverse.
36
C
B
A
B
C
1
2
2
3
1
2
B
1
4