Idiomas disponibles
Idiomas disponibles
English
Owner´s manual
•
Installing or removing flex wheel
Optional accessory
WARNING: Always use supplied guard when flex wheel is on tool. Wheel can shatter during use and
guard helps to reduce chances of personal injury.
Follow instructions for depressed center wheel
but also use back up pad over wheel. See order
of assembly on accessories page in this manual.
1. Lock nut 2. Flex wheel 3. Back up pad 4. Inner
flange
Installing or removing abrasive disc
Optional accessory
NOTE: Use sander accessories specified in this manual. These must be purchased separately.
For 100 mm (4") model
1. Mount the inner flange onto the spindle.
2. Mount the rubber pad onto the spindle.
3. Fit the disc on the rubber pad and screw the
sanding lock nut onto the spindle.
4. Hold the spindle with the shaft lock,
and securely tighten the sanding lock nut
clockwise with the lock nut wrench.
To remove the disc, follow the installation
procedure in reverse.
1. Sanding lock nut 2. Abrasive disc 3. Rubber pad
4. Inner flange
For 115 mm (4 - 1/2") / 125 mm (5") model
1. Mount the rubber pad onto the spindle.
2. Fit the disc on the rubber pad and screw the
sanding lock nut onto the spindle.
3. Hold the spindle with the shaft lock,
and securely tighten the sanding lock nut
clockwise with the lock nut wrench.
To remove the disc, follow the installation
procedure in reverse.
1. Sanding lock nut 2. Abrasive disc 3. Rubber pad
1
2
3
4
1
2
3
4
1
2
3
37
