Mitsubishi Electric Mr.SLIM PLA-A BA6 Serie Manual De Instrucciones página 3

2. Parts Names
Remote controller (Optional parts)
Radio frequency interface
RF thermostat
Note: (Only for IR wireless remote controller)
When using the IR wireless remote controller, point it towards the receiver on the indoor unit.
If the IR wireless remote controller is operated within approximately two minutes after power is supplied to the indoor unit, the indoor unit may beep
twice as the unit is performing the initial automatic check.
The indoor unit beeps to con rm that the signal transmitted from the IR wireless remote controller has been received. Signals can be received up to
approximately 7 meters in a direct line from the indoor unit in an area 45° to the left and right of the unit. However, illumination such as uorescent
lights and strong light can affect the ability of the indoor unit to receive signals.
If the operation lamp near the receiver on the indoor unit is blinking, the unit needs to be inspected. Consult your dealer for service.
Handle the IR wireless remote controller carefully! Do not drop the IR wireless remote controller or subject it to strong shocks. In addition, do not get
the IR wireless remote controller wet or leave it in a location with high humidity.
To avoid misplacing the IR wireless remote controller, install the holder included with the IR wireless remote controller on a wall and be sure to al-
ways place the IR wireless remote controller in the holder after use.
Outdoor unit
Wired remote controller
TEMP.
Ref. Pipes
Indoor-Outdoor
Connection wire
Service Panel
IR wireless remote controller
ON/OFF
Power
Earth
COOL
DRY
AUTO
FAN
HEAT
3