Replacing The Cartridge; Disposal; Information; Potability Of Tap Water - Miomare IAN 274849 Instrucciones De Montaje, De Uso Y De Seguridad

Note: The aerator attachment and aerator
can normally be unscrewed by hand. Otherwise
you can carefully use a pipe wrench SW 22 mm
and you must lay a thin, damp cloth around
the aerator attachment and aerator
you do not damage it.
A pipe wrench with plastic jaws is also suitable.
Non-observance of the above care advice can be
expected to result in damage to the surfaces of the
product. This will inevitably invalidate the guarantee.

Replacing the cartridge

A cartridge is a wear part that needs replacing
6
according to the hardness and / or degree of con-
tamination of the water. This becomes evident when
the handle becomes difficult to move. A new
1
cartridges can be obtained from the listed ser-
6
vice office.
Note: This step requires an open-end spanner
SW 27 mm or fitting pliers.
Proceed as follows to replace the cartridge
Shut off the main water supply. Allow any re-
maining water in the pipework to drain.
Remove the hot / cold plaque
the handle to the highest position and insert-
1
ing a flat object between the edge of the hot /
cold plaque and the outside of the handle
2
Note: Use light pressure to carefully push the
hot / cold plaque
the surface.
Loosen the locking screw
wrench by turning it counter-clockwise.
19
CAUTION! Do not completely unscrew the
locking screw
3
necessary to remove the handle
Remove the handle
Unscrew the cartridge covering ring
use pliers or a spanner. Otherwise the product
could be damaged.
Loosen the cartridge locknut
ting pliers or an open-end spanner SW 27 mm,
and pull the entire cartridge
ting .
9
274849_Waschtisch-Armatur_Modell A_Content_ES.indd 17
Maintenance and Cleaning / Disposal / Information
so that
10
:
6
by adjusting
2
outward so as not to scratch
2
with the socket head
3
. Only loosen this as far as is
.
1
.
1
, do not
4
inside using fit-
5
out of the fit-
6
Insert the new cartridge into the fitting
10
the same manner.
Note: Be sure the seal under the cartridge
is correctly seated. Make sure that the guides
are in the corresponding holes.
Reassemble all the above parts. Tighten the
cartridge lock nut
open-end spanner SW 27 mm while simultane-
ously securing the fitting from twisting. This will
achieve tightness and ensure the handle is not
difficult to move.
CAUTION! Be careful not to reverse the hot /
cold water plaque
left = red (hot water),
right = blue (cold water).

Disposal

The packaging is made of environmen-
tally friendly materials, which may be
disposed of through your local
recycling facilities.
Contact your local refuse disposal authority for
more details on how to dispose of your worn-out
product.

Information

.
1

Potability of tap water

Find out about the potability of your mains wa-
ter supply. Your local water authority or water
supply company will be able to inform you.
The following general recommendations apply to
the potability of tap water:
Let the water run freely for a short time if it has
been stagnating in the pipework for more than
four hours. Do not use any of this stagnant wa-
ter in the preparation of food or for drinking.
This applies particularly as far as babies and
infants are concerned. Health concerns may
otherwise arise. Fresh water can be readily dis-
tinguished from stagnant water as fresh water
is noticeably cooler as it leaves the pipe.
in
9
6
using fitting pliers or an
5
. The correct position is:
2
GB
09.12.15 16:15
17