Start-Up; Operation; Maintenance And Cleaning; Maintaining And Cleaning The Tap - Miomare IAN 274849 Instrucciones De Montaje, De Uso Y De Seguridad

Installation / Start-up / Operation / Maintenance and Cleaning
Tighten the lower eccentric section
lower seal hand tight below the washbasin.
Screw the lower part of the eccentric
upper part of the eccentric
ti-clockwise.
Assembly of the eccentric rod
Fig. B):
Insert the upper part of the pull rod (with the
pull button) from above into the pull rod guide
of the wash basin mixer.
Connect the lower part of the pull rod with the
upper part of the pull rod.
Remove the screw cap from the lower part of
the eccentric.
Remove the stainless steel clip and the connect-
ing piece from the rod.
Insert the bar with the ball and the seal in the
designated opening of the lower part of the ec-
centric and screw these together with the cap.
Note: Please note the seals remain inside the
cap.
Reattach the stainless steel clip and the connect-
ing piece to the ball rod.
Attach the pull rod with the screw to the connect-
ing piece.
Note: The bar of the drain set must be bent
according to the distance, as the bar could oth-
erwise graze the edge.
Screw the flexible connection hoses
angle valves. Be sure to correctly install the
flexible connection hoses
water hoses – left flexible connection hose
to the hot water connection, left angle valve,
and the right flexible connection hose
the cold water connection, right angle valve.

Start-up

After the initial commissioning, carefully check all
connections for leaks.
To remove any possible impurities the tap must be
flushed before being used for the first time. To do
this, proceed as follows:
16 GB
274849_Waschtisch-Armatur_Modell A_Content_ES.indd 16
with the
16
to the
16
by turning an-
16
(refer to
17
Note: If the tap has not been used for a long peri-
od, flush the pipes thoroughly to avoid stagnation
and build-up of residue.
Hot water:
Swing the handle
Cold water:
Swing the handle
to the
18
to the cold- / hot
18
18
Please note that sanitary taps require special care and
to attention. Therefore, please follow the instructions:
18
Unscrew the aerator attachment and aerator
from the spout .
9
Open the main water supply and allow the water
to flow for two minutes to flush out any residues.
Screw the aerator attachment and aerator
back onto the spout .
9

Operation

Open the main water supply.
Lift the handle and swing it to the right or
1
left in order to regulate the speed or tempera-
ture of the water.
to the left.
1
to the right.
1
Check operation of the mixer. To do so, swing
the handle into all permissible positions.
1
Please regularly check the connections are tight.

Maintenance and Cleaning

Maintaining and cleaning the tap

Never clean with petrol, solvents or harsh clean-
ers or hard cleaning brushes, etc. These can
damage the product surface.
Dry your taps with a cloth after every use in or-
der to avoid the build-up of any limescale.
Clean the product with a damp, soft cloth and,
if necessary, mild detergent.
Unscrew the aerator attachment and aerator
at regular intervals and remove any limescale
deposits or foreign bodies. In the event of ex-
cessive dirt or damage replace the the aerator
attachment and aerator
10
10
10
10
with a new one.
09.12.15 16:15