To Mount And Remove Rear Wheels; G.wheel Locks; H.anti-Tips Tubes - Sunrise Medical Breezy Ultra 4 Manual De Instrucciones

B REEZ Y UL TRA 4
F. TO MOUNT & REMOVE REAR WHEELS
Do not use this chair UNLESS you are sure both quick-release axles are locked. An unlocked axle
may come off during use and cause a fall.
NOTE– Setting the wheelchair on a flat surface, such as a workbench or table, helps make these
procedures easier.
1. To Install Wheel
a. Depress quick-release button (A) fully. This will release tension on ball bearings (D) at other end.
b. Insert axle (B) through hub of rear wheel.
c. Keep button (A) depressed as you slide axle (B) into axle sleeve (C).
d. Release button to lock axle in axle sleeve. Adjust axle if it does not lock. See Section B.
e. Repeat steps on other side.
NOTE– The axle is not locked until the quick-release button(D) pops out fully. Check that the axle is locked
by pulling on the wheel in the direction of the axle.
2. To Remove Wheel
a. Depress quick-release button (A) fully.
b. Remove wheel by sliding axle (B) completely out of axle sleeve (C).
c. Repeat steps on other side.
13
G. WHEEL LOCKS
Wheel locks are installed by the manufacturer and should be adjusted by your authorized dealer. Inspect wheel
locks weekly per the maintenance chart. Do not use your chair UNLESS you are sure both wheel-locks can fully
engage. A wheel-lock that is not correctly adjusted may allow your chair to roll, or turn unexpectedly. Wheel-
locks must be adjusted after making sure the tires have the correct air pressure. When fully engaged, the wheel-
lock arm (E) should be imbedded into the tire at least 1/8" to be effective.
If you find the wheel locks have slipped or are not working correctly contact your service provider for proper
adjustment.
H. ANTI-TIP TUBES (OPTIONAL)
Breezy recommends anti-tip tubes for all wheelchairs.
1. Inserting Anti-Tip Tubes Into Receiver
a. Press the rear anti-tip release pin (F) on the anti-tip tube so that the release pin is drawn inside.
b. Insert into the anti-tip tube receiver(G).
c. Turn the anti-tip tube down until release pin is positioned through the receiver mounting hole.
d. Insert second anti-tip tube the same way.
2. Adjusting Anti-Tip Tube Wheel
The anti-tip tube wheels may have to be raised or lowered to achieve proper clearance of 1 1/2" to 2".
a. With the thumb and forefinger, press the anti-tip wheel release pins (H) so that the release pins are
drawn inside, and the anti-tip wheels can be moved.
b. Raise or lower to one of the three predrilled holes.
c. Release pins. When the pins(H) are visible the anti-tip wheels are locked.
d. Adjust the second anti-tip tube wheel the same way. Both wheels should be at exactly the same height.
MK-100078 RevA
11 12
WARNING
WARNING
14
15
14
VIII. USE AND MAINTENANCE
G
H
11
12
13
14
15