Idiomas disponibles
Idiomas disponibles
Connecting electrical power to the reversing video camera
Protect every through-hole made in the outer skin of the bodywork against water pen-
etration, for example by using a cable with a sealant and by spraying the cable and the
cable sleeve with sealant.
I
NOTE
Only start sealing through-holes when you have completed all installation
work on the camera and have laid the required cable lengths.
Pull the socket connector of the camera cable through the cable bushing
sleeve before inserting the sleeve in the bodywork.
➤ Route the camera cable into the interior of the vehicle so that it cannot be damaged
under any circumstances (e.g. by gravel impact).
➤ Lay the camera cable so that should you need to remove the camera, you can easily
access the plug connection.
This facilitates the disassembly considerably.
8
Connecting electrical power to the reversing video
camera
The circuit diagram for the reversing video camera can be found in fig. 6, page 5.
No. in
fig. 6, page 5
1
2
3
4
5
Connecting the camera
I
NOTE
Make sure the plug connections are assembled in such a way that the arrows
on the plug and the socket are pointing at each other (fig. 5, page 5).
➤ Insert the plug of the camera cable (fig. 6 2, page 5) as far as it will go into the 6-pin
socket (fig. 6 3, page 5) of the connection cable.
Make sure that the plastic cap of the socket reaches up to the arrow on the plug.
➤ Connect the 6-pin plug (fig. 6 4, page 5) on the connection cable to the monitor.
20
Designation
Camera
6-pin mini DIN plug
6-pin mini DIN socket
6-pin mini DIN plug
Monitor with 6-pin mini DIN socket
CAM29
EN
