Idiomas disponibles
Idiomas disponibles
8.3
Workpiece clamp
8.2
8
Fitting the workpiece clamp
► Fit the workpiece clamp [8.1] into one of the
two holes [8.2]. The clamping unit must
point towards the rear.
► Twist the workpiece clamp so that the
clamping unit faces forward.
8.4
Dust extraction
WARNING
Health hazard posed by dust
► Always work with an extractor.
► Comply with national regulations.
► Wear a dust mask.
9.1
9a
A Festool dust extractor with an extractor hose
diameter of 1-7/16" or 1-16" (36 mm or 27 mm).
(1-7/16" (36 mm) recommended due to the re
duced risk of clogging) can be connected to the
extractor connector [9.1].
8.1
9.2
The flexible chip deflector [9.2] improves the
collection of dust and chips. Therefore, never
work without a fitted chip deflector.
9b
The chip deflector is clamped in position on the
guard with the clamp [9.3]. For this, the
hooks [9.4] of the clamp must lock into the re
cesses [9.5] of the guard.
8.5
Adjusting the table extension
► Open the knob [1.9].
► Pull out the table extension [1.8] far enough
that the workpiece is laid out fully.
► Close the rotary knob.
If, despite the table extension being
extended as far as possible, the work
piece protrudes over the table, the
workpiece must be supported by oth
er means.
8.6
Workpiece stop
10.1
10
Adjusting the stop ruler
For mitre cuts, you must adjust the stop rul
ers [10.1] so that they do not impede the func
tionality of the pendulum guard or come into
contact with the saw blade.
► Open the clamping lever [10.2].
English
9.3
9.4
9.5
10.2
10.3
15
Capítulos
