GE GXCC01D Manual Del Propietário página 9

Possible Causes What To Do
Water dispenser is noisy Water dispenser is uneven. * Make sure the water is installed on a level floor or counter
strong enough to support it when flflly loaded.
Bottle maMng a gurgfing noise * This is nom_al.
as water fills the tanks.
Hot water boiling sound. * This is nomlal.
Dispenser or water bottle shakes * This is nomlal.
when the cooling system cycles off.
Particlesfloatingin
Water has high mineral content. * Find a water source with lower hardness.
water
Foul odorin airaround
Hot water tank is empty or not * Press the hot dispenser button until water flows to remove
dispenser
completely full. air flom the hot rank.
Chiller does not operate
Chiller is not on. * Turn the (k)/d power switch on, if equipped.
(chiller models only)
Water dispenser is unplugged. * Push the plug completely into the outlet.
The fuse is blown/circuit * Replace fl_se or reset the breaker
breaker is tripped.
Vibration orrattling
Water dispenser is on * Use shims to level the unit.
(slight vibration an uneven surface.
is normal)
=
Compressor/motor
Often occurs when
* This is nom_al.
operates (cooling light on)
large amounts of food
for long periods or cycles are placed in cooler.
(chiilermodels only) Door left open. * Check to see if package is hoMing door open.
Hot weather or frequent * Tiffs is nomlal.
door openings.
Compressor/motor
Normal when unit * Wait 24 hours for the unit to completely coo/down.
operates (cooling light on) is first plugged in.
for long periods or cycles
(all models) Not enough clearance * Make sure there is enough air circulation around
from the wall. the unit.
Water system overtired. * Dispense water flom the coM faucet until air is released
into the |)()tOe.
Chiller compartment
too Door left open. * Check to see if package is holding door open.
warm (chiller models only)
Compartm-ent/co/d
water
Low ambient temperature.
* Place units in room temperature
environment.
too cold/frozen
Chiller compartment has
Foods transmitting odor
* Foods
with strong
odo_ should
be tightly wrapped.
odor (chillermodels only)
to chiller.
* Keep an open
box of baking soda in the unit;
replace every three months.
Interior needs cleaning. * See Care
and cleaning.
Moisture forms on outside Not unusual during * Wipe surface dry.
of chiller compartment
periods of high humidity * Operate unit in temperature- and humiditT-controlled
(chiller models only)
and/or temperature,
location.
• Place unit in tray to contain moisture accumulation.
Too frequent or too long
door openings.
Moisturecollectsinside
chillercompartment
(in humidweather,air
carries moisture into
chillercompartment w hen
dooris opened)(chiller
modelsonly)
* Minimize time door is open.
* Wipe surface dry.
* Empty internal drip tray.
* Operate
trait in mmperamre- and humidity-controlled
location.
* Place unit in tray to contain moisture accumulation.
9