Idiomas disponibles
Idiomas disponibles
Excessive overloading the motor will pulsating reduce
the speed 6 times electronically to warn the operator.
The LED lights will flash red-green/green-red and then
remain red. The motor switches off automatically and
can immediately be switched back on again.
Soft starter
To use the soft starter first switch on the machine. If the
softstarter button 2 is pressed, the machine runs for
10 seconds at half speed. For that time the first LED
then lights up purple instead of blue. An easy drilling
start of the surface to be drilled is with this facilitated.
NOTE
Use the soft starter only for a short time at
drilling start in the surface to be drilled.
Slip clutch
With a clamping drill, the slip clutch is activated. All
LED lights could flash red. The machine is switched
off automatically. Carefully loosen the drill. Never use
the ON/OFF switch 1 for this! You can then calmly
resume drilling.
Undervoltage protection
If the machine detects a too low voltage supply, the
machine is switched off. All LED lights 3 will then con-
tinue to lit blue.
Switch the machine off and on again.
Drilling with a drill stand
Drill stand fixation
CAUTION
The drill stand must always be mounted
firmly and must not be able to move during
drilling.
Aligning the drill stand
Set up the drill stand at the drilling location.
■
Rotate the centering plate 25 forwards, until it
■
snaps in.
Align the drill stand in such a manner that for
■
the used machine the tip of the centering plate
is located directly above the required drilling
location.
Fasten the drill stand.
■
Secure using assembly
Drill the rawlplug hole Ø 16 mm for rawlplug
■
W-ED M12.
Insert rawlplug.
■
Screw in assembly 16.
■
14
Align the drill stand.
■
Fasten the drill stand with the spindle nut 17.
■
Vacuum pump fixation
WARNING
Maximum drilling diameter of 100 mm.
Mount the drill stand on an even, firm and
smooth surface using the vacuum pump,
never "over" head.
Always connect the core drill and the vacuum pump
to the same power outlet. Never turn off the vacuum
pump during operation.
Position the machine horizontally. Maximum tilt
■
of 10°. Fasten, mount suction hose and fasten
■
with hose clip. Fasten the drill stand.
See further the vacuum pump manual.
Mounting the drill bit
Tighten the clamping screw 13.
■
Clean and grease the thread on the drill bit 30
■
and the tool holding fixture 7.
Screw a core bit 30 onto the tool holder 7 and
■
tighten with supplied wrenches.
Connecting the water feed
Close the water tap 6.
■
Connect the water feed hose to the water tap or
■
the water pressure tank.
When using the water pressure tank, make sure
■
that there is sufficient pressure when working.
Check the water flow indicator 9.
■
Setting the drilling angle
Loosen the clamping screw 19.
■
Use handle 20 to slide the column into the
■
desired drill angle using the scale.
Tighten the clamping screw 19.
■
Drilling
Always ensure a adequate anchorage in the
■
underground.
Open the water tap 6.
■
Loosen clamping lever 13 and hold the feed lever 10.
■
Actuate the ON/OFF switch 1.
■
You can use the soft starter 2 at drilling start. Drill
■
using an even forward feed. Do not overload the
machine.
The leaking water should be milky and not clear.
■
Always loosen the clamping lever 13 when
■
drilling.
After drilling switch off the machine and shut off
■
the water tap. Lift the machine with feed lever 10
and secure with clamping lever 13.
