Hama Black Line Plus Instrucciones De Uso página 7

Ocultar thumbs Ver también para Black Line Plus:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35
Note – Faulty transfer of measured
values
• In some cases, interference caused by a WiFi network,
computer, TV, etc., for example, may cause the
transmission of measurement values between the
base station and the outdoor sensor to fail.
• In this case, you must resynchronise the stations by
brie y removing the batteries from both stations and
reinserting them.
• If the measured values are not transferred again once
the batteries are inserted, replace the batteries with
new ones.
• If necessary, select a new location for the base station
in order to avoid possible interference in the future.
6.2 Channel selection / Additional outdoor sensors
Note
• You can install two further outdoor sensors in
addition to the outdoor sensor supplied. When doing
so, ensure the same channel setting on the base
station and each outdoor sensor.
• Suitable outdoor sensors can be found at
www.hama.com
• Press the
key (E) repeatedly to set the same channel
as on the outdoor sensor in question. Channel 1, 2 or
3 is displayed.
• If the
symbol is displayed, the weather station will
automatically switch the displayed channel every ve
seconds.
6.3 Basic and manual settings
Automatic setting using the DCF signal
• After switching on the base station for the rst time and
successfully transferring data between the base station
and outdoor sensor, the clock automatically starts the
search for the DCF signal. The radio symbol (7) ashes
during the search process.
Display
Display ashing
Displayed continuously
No display
• If the station still does not receive a signal, press and
hold the
button (C) for approx. 3 seconds to start
the manual search for the DCF signal. The wireless
symbol (7) will start to ash.
• When the wireless signal is received, the date and time
are automatically set.
Note – Time settings
• The search process takes about 7 minutes. If the search
fails, it ends and is repeated at the next clock hour.
• In the meantime you can, however, set the time and the
date manually.
• The clock automatically continues to search for the DCF
signal on a daily basis (between 1:00 a.m. and 5:00
a.m.). If the signal is received successfully, the manually
set time and date are overwritten.
• Press and hold the
approximately 3 seconds to stop the manual search.
Note – Summer time
The clock automatically switches to summer time. S
(8) appears on the display as long as summer time is
activated.
Searching for the DCF
signal
Active
Successful – signal is being
received
Inactive
button (C) again for
6
loading

Este manual también es adecuado para:

00186418