Idiomas disponibles
Idiomas disponibles
2 Check the cloning cable connection on both Single-Unit Chargers (SUC) and if the cable is
switched to "Cloning".
3 Ensure that there is no debris in the charging tray or on the radio contacts and the radio contact
is touching the SUC or Multi-Unit Charger (MUC) contact firmly.
4 Ensure that the target radio is turned on.
5 Ensure that the source radio is in cloning mode.
6 Ensure that the two radios are both from the same frequency band, same region and have the
same transmission power.
NOTE: The cloning cable is designed to operate only with compatible Motorola Solutions
SUC, PMLN7139_.
When ordering cloning cable kit, ensure to order the cloning cable kit with part number HKKN4028_
For more information about the accessories, see
12.6
Cloning Mode Using Wireless PROFILE ID Number
The PROFILE ID Number Wireless Cloning feature is useful when you want to clone the PROFILE ID
number for all the radios in your fleet, but you do not want to clone particular radio settings that may be
unique for each radio such as Top button configuration, MIC Gain, Radio Name and others. Wireless
PROFILE ID preserves each user radio setup, but ensure that all radios are under the same PROFILE
ID number. This feature is useful if you do not have a programming Cable, Cloning Cable, or PC easily
available.
12.6.1
Configuring Cloning Mode Using Wireless PROFILE ID Number
Procedure:
1 Turn the Source Radio on by performing the following actions:
a Press the PTT and Volume Down buttons at the same time while turning the radio on.
b Wait three seconds before releasing the buttons until you hear "Clone Mode Serial" voice
prompt from the Source radio.
a Press and release the Volume Down button.
You hear "Wireless" from the Source radio.
2 Turn on the Target radio by performing the following actions:
a Press the PTT and Volume Down buttons at the same time while turning the radio on.
b Wait three seconds before releasing the buttons until you hear "Clone Mode Serial" voice
prompt from the Target radio.
NOTE: Avoid putting powered on radios (more than seven radios) in a container
together, other than the Multi-Unit Charger.
3 To start the wireless PROFILE ID Number cloning on the Source Radio, press and release the
Volume Up button.
•
You hear a tone.
•
After cloning is completed, you hear "Pass" indicating cloning is successful or "Fail" indicating
cloning failed voice prompt from the Source radio.
Accessories on page 75
MN003596A01-AB
Chapter 12 : Cloning Mode
67
