Idiomas disponibles
Idiomas disponibles
12.2.1
Configuring Cloning Mode in Multi-Unit Charger
Prerequisites: Ensure all radios are fully charged.
Procedure:
1 Turn on the target radio.
2 Place the target radio into the Multi-Unit Charger (MUC) target pocket. See
Multi-Unit Charger on page 63
3 To turn on the source radio, press PTT and Volume Down buttons simultaneously for three
seconds.
You hear Cloning Mode beeps, and your radio announces "Cloning Mode, Serial".
4 Place the source radio into the paired MUC target pocket. See
Charger on page 63
5 Press the + button.
Your radio announces "Fail" or "Pass".
6 To exit Cloning Mode, long press the PTT button.
NOTE: When ordering MUC, ensure to order MUC with part number PMLN7135_.
12.3
Configuring Cloning Mode Using Radio to Radio Cloning Cable
Prerequisites:
Ensure all radios are fully charged.
Required devices/tools:
•
Cloning Cable (Part Number HKKN4028_)
•
Two Single-Unit Chargers (SUC)
When and where to use:
Figure 17: Radio to Radio Cloning
Procedure:
1 Turn the radio off.
2 Unplug any cables from the SUC.
for the correct placement.
for the correct placement.
MN003596A01-AB
Chapter 12 : Cloning Mode
Cloning Mode in
Cloning Mode in Multi-Unit
65
