Idiomas disponibles
Idiomas disponibles
6
Installation
Figure 32: Spring preload
Check the spring preload travel between the swivel wedge
and the cable store, as shown in Figure 32.
If the measured spring preload travel deviates, readjustment
is necessary.
ATTENTION!
The spring preload travel can only be changed by adjust-
ing the position of the cable store.
Figure 33: Installing the cable store base plate
Insert the base plate in the cable store, as shown in Figure 33.
Push the base plate into the cable store until the base plate
meets the side panels.
Fasten the base plate to the side panels of the cable store
using the supplied screws M6x15 (4x).
IMPORTANT!
Tightening torque: Screw M6x15 = 10 Nm
MUB 007 004 M01 (REV--) 05-2023
75
