Idiomas disponibles
Idiomas disponibles
Temperature Dry Well Calibrators/Micro Calibration Baths
CTD9100/CTB9100
2. Safety Instructions
GB
Always read the operating instructions carefully
prior to using the new product. Always adhere to the
instructions contained herein, especially the safety
instructions; otherwise, there is a potential risk of
operator injury and damage to the calibrator and the
sensors being tested.
Even though WIKA provides assistance for the use
of the product through personal consultation or the
respective literature, it is the responsibility of the
customer to determine the suitability of the product
for the specific application.
The temperature calibrator/micro calibration bath
is a state-of-the-art device. This relates to the
accuracy, functioning and the safe operation of
the calibrator/micro calibration bath. However,
professional and safety conscious conduct of the
operator is required to ensure safe operation.
2.1 Qualified personnel
The personnel entrusted with start-up, operation
and maintenance of the calibrator/micro
calibration bath have to be suitably qualified; the
required knowledge can be gained via train-
ing courses or appropriate on-the-job instruc-
tion. The personnel have to be familiar with the
contents of these instructions, which have to be
available to them at all times.
The electrical connection should only be carried
out by a fully qualified electrician.
All work has to be carried out in accordance
with existing national regulations on accident
prevention and safety at work and with any
internal regulations of the operator, even if they
are not specified in these instructions.
Always observe the safety information contained
in these operating instructions.
2.2 Basic safety regulations
Only operate the calibrator/micro calibration bath
when it is in correct, fully functional condition.
The calibrator/micro calibration bath is energized
with hazardous voltages via a mains cable.
Improper use can result in personal injuries.
Correct and safe operation of the calibrator/
micro calibration bath demands correct
transport, storage, installation and assembly,
as well as proper use and careful operation and
maintenance.
The calibrator/micro calibration bath should only
be used for its intended purpose. Furthermore,
hazardous media should not be used and all
technical specifications have to be observed.
6
WIKA Operating Instructions Temperature Dry Well Calibrators/Micro Calibration Baths
If faults cannot be cleared, immediately shut
down the calibrator/micro calibration bath and
ensure that it cannot be started up accidentally.
Repairs should only be carried out by the
manufacturer. Tampering with or modifying
the calibrator/micro calibration bath is strictly
prohibited.
Prior to replacing the safety fuse, always de-
energize the calibrator/micro calibration bath
completely by disconnecting the mains cable
from the mains outlet.
Ensure that the complete operating instructions
are always available in excellent condition at the
calibrator/micro calibration bath installation site.
Ensure that calibrator/micro calibration bath
operators receive regular instruction in the
various aspects of occupational health and
safety and environmental protection and have full
knowledge of these operating instructions and
the safety information contained herein.
Thermal fuse
For protection purposes, the calibrator/micro
calibration bath is equipped with an autonomous
thermal fuse, which interrupts the power supply
to the heater if the temperature exceeds a
certain value inside the housing. Once the metal
bock/liquid bath has cooled down, the calibrator/
micro calibration bath has to be returned to
WIKA for inspection.
The calibrator/micro calibration bath has
been designed as a measurement and control
instrument. If the calibrator/micro calibration
bath is used for purposes not expressly specified
in these operating instructions, additional safety
measures have to be taken.
The calibrator/micro calibration bath should NOT
be used in explosive atmospheres without
appropriate protection (flammable or explosive
atmospheres).
If malfunctioning of the calibrator/micro
calibration bath can result in personal injuries
or damage to property, the system has to be
protected with additional electromechanical
protective equipment.
