End Run Device; Turning Off And Standby Of The Machine; Adjustement - Colged TopTech 31-22.1 Manual De Instrucciones

The machine must operate with a limit switch installed on the basket exit surface (see installation chapter).
The "Limit switch ON" and the
reaches the end of the surface and the drive system stops until the basket is removed.
Just remove the basket from the end of the surface to re-start the machine completely.
If the basket is not removed within a few minutes, the machine will switch off the rinse, wash, pre-wash and
finally the drying areas in sequence, where installed.
Reference figure 1
To turn off the machine, press the line button (1) which will turn red.
The display will remain on for a few minutes after which it will go off completely.
It is possible to lock the display during standby by pressing the button
pressing the button.
This last function makes it possible to clean the display surface.
The user can adjust the temperatures and dosing times.
With reference to figure 7

Access the adjustments menu by pressing the

Press the icon to access the adjustment menu (fig.7/B)

The access password

Enter "0" "1" "2" using the

Now, using the arrows, it is possible to display all temperature sets.

To modify the parameter displayed, the menu key
using the

Adjustments cannot be made with washing in progress.
MDITT31-(r06)
DISHWASHER INSTRUCTIONS MANUAL
icon are shown on the display when a basket exiting the machine
.
must be entered.
keys to change the number and the
keys it is successively possible to set the desired value.

Turning off and Standby of the machine

and then reactivate it by
icon (fig.7/A)
must be pressed (the set box is highlighted) and
UK

End run device

Adjustement

key to move to the next
Page 21 of 33