Installation Of Dispensers - Colged TopTech 31-22.1 Manual De Instrucciones

UK
The machine is equipped with specific outputs for rinse aid and detergent dosing devices. Connect the
dosing devices as shown in the wiring diagram to ensure the correct operation of the machine.
The rinse aid and detergent must be dosed by the automatic dispensers.
The amount of both of these products is established by the installation technician based on local water
hardness, and the technician also calibrates the dispensers themselves.
For the initial filling of the dosing circuit and the relative settings, see the "Settings" paragraph.

The level of liquids in the containers must never be allowed to reach empty.

The dispensers must never be filled with corrosive or contaminated products.

Chlorine-based products must not be used under any circumstances, as they cause the formation of
chloride, which in concentrations above 50 ppm can lead to corrosion

It is not advisable to dispense the products manually.

For any other installation, refer to the wiring and installation diagrams enclosed

The machine cannot be fitted with multi-voltage dosing devices and/or dosing devices with
absorption higher than 5A per output.
If you wish to use this type of dosing device, it must be connected to an external 16A relay
WARNING!

The use of detergents containing chlorides in a concentration exceeding 50 ppm can lead to corrosion
of the machine's stainless steel structure.
The machine is equipped with protection curtains to separate the various sections of the machine.
For the assembly diagram, see figure 19.
Page 14 of 33
DISHWASHER INSTRUCTIONS MANUAL

Installation of dispensers

Installation of protection curtains
MDITT31-(r06)