Connection To Water Supply - Colged TopTech 31-22.1 Manual De Instrucciones


The power supply cable must not be stretched or crushed during normal operation or routine
maintenance.

The appliance must also be connected to an equipotential system with a screw marked with the symbol
.

The equipotential cable must have a cross section of 10 mm².
Do not use multi-sockets, adapters, cables of an inadequate cross-section or type or with
extensions not conforming to established electrical installation regulations.
If the local mains water is harder than the value indicated on the data plate, we recommend installation
of a water softener upline of the machine's solenoid inlet valve.
If the water has a very high residual concentration of high conductivity minerals, we recommend
installation of a demineralisation system calibrated to achieve residual hardness as indicated in the table
below.
Hardness
Mineral
residues
(TDS)
MDITT31-(r06)
DISHWASHER INSTRUCTIONS MANUAL

Refit the front cover panel and the control panel using the screws
provided.
Prepare the installation site according to the installation diagram attached.
Before connecting the appliance, make sure that there is a gate valve installed
between the mains water supply and the machine, allowing the water supply to
be shut off in case of need or when carrying out repairs.
In addition, make sure that the water supply flow rate is no lower than 20 l/min.
Warning!

Make sure that the temperature and pressure of the mains water supply
are within the range of pressure and temperature values indicated on
the technical data plate.
If they are not, it will not be possible to achieve suitable water flow rates
and temperatures for proper rinsing.
Characteristics
French degrees
German degrees
English degrees
Parts per million
(20°C)

Connection to water supply

Min
f 5
°dH 4
°e 5
ppm 70
mg/l 70
UK
Max
10
7.5
9.5
Page 11 of 33