Colged TopTech 31-22.1 Manual De Instrucciones página 15

 Before connecting the appliance, make sure the details on the data plate match
those of the mains power and water.
 Check that the electrical capacity of the system is adequate for the maximum
power absorbed by the appliance. If in doubt, contact a qualified person who
must check that the cross-section of the system cables is suitable for the power
absorbed by the appliance.
 The incoming power supply cables (not provided) to the main switch must be
indicated with the appropriate danger warnings.
 The appliance power supply cable must be H07RN-F type.
 The installer technician must check the efficiency of the "earth" as required by
the applicable safety standards. This fundamental safety requirement must be
respected; if in doubt, request a thorough inspection of the entire system by
professionally qualified personnel.
 At the end of testing, the installer technician must issue a written declaration
regarding correct installation and testing according to the applicable
regulations and highest standards.
 DO NOT modify the protection devices. Remove them only if the machine is
stopped and disconnected from the power supply; reinstate them before
reconnecting it to the power supply.
 After disconnecting the power supply, only qualified personnel may access the
control panel.
 DO NOT change the position of or tamper with the machine's parts, as this
could compromise its safety.
 DO NOT use dispensing devices or other devices not prescribed by the
manufacturer, which may alter the machine's safety or operating
characteristics.
 Noise pressure level according to EN ISO 4871
o LpA Max = 68.0db Kpa=2.5db for versions without drying
o LpA Max = 69.5db Kpa=2.5db for versions with drying
 Max inlet water temperature: 65°C
 Max inlet water pressure: 4bar (400kPa)
 Appliance designed for permanent connection to the water supply
 For cleaning operations, carefully follow the instructions provided in the
manufacturer's handbook.
 The appliance must NOT be cleaned with steam or water jets.
 Only use anti-foaming detergents specific for dishwashers, in the doses
recommended by the manufacturer according to the water hardness and tank
capacity.
 Never use acidic or corrosive products to clean the machine or to wash dishes.
 Never use products containing chlorides in concentrations above 50 ppm as a
dishwasher detergent or to clean the machine.
 Never use steel wool pads, steel brushes or shavings to clean the stainless
steel.
MDITT31-(r06)
DISHWASHER INSTRUCTIONS MANUAL
UK
Page 5 of 33