Troubleshooting - Fujitsu ASU30CLX1 Manual De Funcionamiento

TROUBLESHOOTING

WARNING!
Before requesting service, perform the following checks:
NORMAL Doesn't operate immedi-
FUNCTION ately:
Noise is heard:
Smells:
Mist or steam are
emitted:
Airfl ow is weak or stops:
9315345363_OM.indb Sec1:14 9315345363_OM.indb Sec1:14
In the event of a malfunction (burning smell, etc.), immediately stop operation, turn off the electri-
cal breaker or disconnect the power supply plug, and consult authorized service personnel.
Merely turning off the unit's power switch will not completely disconnect the unit from the power
source. Always be sure to turn off the electrical breaker or disconnect the power supply plug to
ensure that power is completely off.
Symptom
● If the unit is stopped and then immediately started again, the com-
pressor will not operate for about 3 minutes, in order to prevent
fuse blowouts.
● Whenever the Power Supply Plug is disconnected and then recon-
nected to a power outlet, the protection circuit will operate for
about 3 minutes, preventing unit operation during that period.
● During operation and immediately after stopping the unit, the
sound of water fl owing in the air conditioner's piping may be
heard. Also, noise may be particularly noticeable for about 2 to 3
minutes after starting operation (sound of coolant fl owing).
● During operation, a slight squeaking sound may be heard. This is
the result of minute expansion and contraction of the front cover
due to temperature changes.
● Some smell may be emitted from the indoor unit. This smell is the
result of room smells (furniture, tobacco, etc.) which have been
taken into the air conditioner.
● During Cooling or Dry operation, a thin mist may be seen emit-
ted from the indoor unit. This results from the sudden Cooling of
room air by the air emitted from the air conditioner, resulting in
condensation and misting.
● The fan may operate at very low speed during Dry operation or
when the unit is monitoring the room's temperature.
● During SUPER QUIET operation, the fan will operate at very low
speed.
● In the monitor AUTO operation, the fan will operate at very low
speed.
Problem See Page
—
—
—
—
6
6
6
En-14
9/16/2010 2:48:52 PM 9/16/2010 2:48:52 PM