Hang ups Teeter F9000 Manual Del Usuario página 4

ASSEMBLY
STEP SIX
Attach the Tether Strap (F5-1008) to Limit the Degree of Rotation
• Attach the clip to the desired strap angle and hook the clip to the loop at
the base of the table bed.
• 20° - Secure the clip to the green strap for inversion to a gentle 20°.
• 40° - Secure the clip to the blue strap for inversion to a moderate 40°.
• 60° - Secure the clip to the black tip of the strap for inversion to a
more advanced 60°. This is the angle when all the benefits of inversion
are realized.
• 90° - Remove the tether strap entirely for full inversion and exercise!
POST ASSEMBLY ADJUSTMENTS
CHANGING THE ROLLER HINGE SETTING
• Stand with your legs on either side of the main shaft.
• Reach under each roller hinge with your index fingers. Use your thumbs to
release the locks over the roller hinges. (See Figure 7)
• Lift both sides of the table out of the A-frame at the same time. You may
rest the table on the crossbar of the A-frame.
• Unlock the cam locks for each roller hinge. Change the roller hinges to
the desired setting (A, B, or C, from most aggressive to least aggressive).
(See Figure 8)
• Relock the cam locks. Replace the roller hinges into the hinge plates of
the A-frame.
Assembly Instructions
STEP SEVEN
Testing the Assembly
PRIOR TO USE:
• Test the table by hand for smooth and steady rotation.
• Ensure all fasteners are secure.
You have completed the assembly of your Teeter Hang Ups
• Read your Owner's Manual thoroughly before using the inversion table. Improper
settings could result in serious injury or death.
• For your reference, the table's serial number can be found at the base of the table
frame on the back.
MAINTENANCE
Hook tether
strap here.
60° black
40° blue
20° green
No Strap:
90°
STORAGE
Figure 7
Figure 8
Shows pin in
Setting C
Figure 6
Inversion Table.
®
A
B
C
II-L202 Pg. 3