Hang ups Teeter F9000 Manual Del Usuario página 3

ASSEMBLY
STEP THREE
Install Roller Hinges (F5-1064) to Table Frame (F8-1021)
• For ease of assembly, rest the table frame against the crossbar at the
front of the A-frame.
• Open the cam locks on each side of the table frame.
• With the grooved pivot pins facing out, insert the roller hinges into the
brackets on each side of the table frame. (See Figure 3) The roller hinges
will slide between the cam locks and the brackets. (See Figure 3A)
• Make sure that the roller hinges are in the same hole setting on both
sides.
• Push down on the cam lock to secure the hinge. Figure 3B shows the
roller hinge engaged correctly (in Setting C).
Refer to the Owner's Manual for an explanation of the hole settings.
We suggest using Setting C to start.
Figure 4
STEP FIVE
Insert the Main Shaft (F9-1039) into the Table Frame (F8-1021)
• Loosen the de-rattler knob on the main shaft housing.
• With the height adjustment settings on the main shaft facing up, slide the
end of the main shaft into the blue bushing in the main shaft housing. (See
Figure 5)
• Pull out the height selector locking pin to allow the main shaft to slide in
further. For the purpose of easy assembly, slide the main shaft in all the
way and release the pin in the storage setting. (Refer to the Owner's
Manual for proper height adjustment before use).
• Tighten the de-rattler knob.
Read the Owner's Manual for information on
selecting the correct user height setting.
Improper settings could result in serious injury or death.
Assembly Instructions
STEP FOUR
Attach the Table Frame (F8-1021) to the A-frame (F7-1002)
• Holding each side near the roller hinges, pick up the table frame and stand at
the front of the A-frame. Lower each pivot pin into the A-frame hinge plates at
the same time. (See Figure 4) Figure 4A shows the correct placement of the
pivot pin into the hinge plate.
• Make sure that both pivot pins are seated at the base of the slot in the
hinge plate.
• Check to make sure that the self-locking hooks have closed over both
pivot pins and that the table rotates smoothly.
Failure of the self-locking hooks to close over both pivot pins
Figure 4A
WARNING
!
Figure 3
WARNING
!
is indication of improper assembly and if not corrected,
could result in serious injury or death.
Figure 5
In Setting C
Hinge
into
bracket
Close
cam lock
Figure 3A Figure 3B
de-rattler
knob
II-L202
pivot
pin
Pg. 2