Worx WT351.X Manual Original página 9

Waste electrical products must not
be disposed of with household
waste. Please recycle where
facilities exist. Check with your local
authorities or retailer for recycling
advice.
COMPONENT LIST
1. CHUCK
2. TORQUE ADJUSTMENT RING
3. TWO-SPEED GEAR CONTROL
4. FORWARD/REVERSE ROTATION CONTROL
5. SOFT GRIP HANDLE
6. BATTERY PACK *
7. BATTERY PACK RELEASE BUTTON *
8. SIGHT LIGHT
9. ON/OFF SWITCH
* Not all the accessories illustrated or
described are included in standard delivery.
TECHNICAL DATA
Type WT351 WT351.X (3-designation of
machinery, representative of hammer drill)
Charger voltage
Rated voltage
No load speed
Impact rate
Number of clutch position
Max torque
Chuck capacity
Steel
Max. drilling
Wood
capacity
Masonry
Cordless hammer drill
WT351 WT351.X **
100-240 V ~50/60 Hz
20 V Max***
0-400/0-1500 min
0-6400/0-24000 bpm
18+1+1
40 N.m
13 mm
13 mm
30 mm
13 mm
Machine weight (bare
tool)
**X=1-999, A-Z, M1-M9 there are only used for
different customers, there are no safe relevant
changes between these models
***Voltage measured without workload. Initial
battery voltage reaches maximum of 20 volts.
Nominal voltage is 18 volts.
NOISE INFORMATION
A weighted sound pressure
A weighted sound power
K & K
PA WA
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 62841:
Vibration emission
Impact drilling value a
into concrete
Uncertainty K = 1,5 m/s²
Vibration emission
value a
Drilling into metal
Uncertainty K = 1,5 m/s²
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways
in which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
1.1 kg
L : 76,7 dB(A)
pA
L : 87 ,7 dB(A)
wA
5.0 dB(A)
= 4,683 m/s²
h,ID
= 2,722 m/s²
h,D
EN
9