Care and maintenance - Cooktop
Control knobs
Turn off all burner knobs.
01
01 Grasp each knob and pull to remove.
02 Valve stem. Do not remove.
78
English
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 78-79
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 78-79
1. Pull the knobs off their valve stems.
2. Clean the knobs in warm, soapy water,
then rinse and dry them thoroughly.
02
3. Clean the stainless-steel surfaces using
stainless-steel cleaner.
4. Re-attach the knobs in the Off position
to the control valve stems.
CAUTION
• Do not clean the control knobs in a dish
washer.
• Do not spray cleaners directly onto
the control panel. Moisture entering
the electric circuits may cause electric
shock or product damage.
Burner grates and components
Turn off all surface burners and make sure they have all cooled down.
1
1
2
2
3
3
CAUTION
•
The starter electrodes are not removable. Do not attempt to remove them by force.
•
Make sure all burner components (heads and caps) are reinstalled properly. When
installed properly, they are stable and rest flat.
•
To avoid chipping, do not bang grates and caps against each other or hard surfaces
such as cast iron cookware.
•
The burner ring can be blocked by food or dust. Clean the ring if it appears blocked.
If you clean the spreader with water, assemble it only after it is completely dry. If
the ring is wet, it might prevent the burners from igniting.
1. Remove the burner grates.
2. Remove the burner caps from the
burner heads.
3. Remove the burner heads from the
valve manifolds to reveal the starter
electrodes.
4. Clean the grates and burner
components in warm, soapy water. (Do
not use steel-wool pads or abrasive
cleaners.)
5. Rinse and dry grates and burner
components thoroughly. Ensure the
burner ports are free of water.
6. Reassemble the burner heads, making
sure to insert a starter electrode
through the hole in each head.
NOTE
See page 82 for details on how to
reassemble the burner components.
7. Reassemble the remaining burner
components, making sure the caps lie
flat on top of the heads.
8. Re-install the burner grates in their
respective positions.
9. Turn on each burner to verify that
it works properly, then turn off the
burner.
English
2023-01-17 오후 3:01:59
2023-01-17 오후 3:01:59
79