Idiomas disponibles
Idiomas disponibles
3. Slide the shoe back into the 0° positive stop position.
4. Lock the shoe.
Cutting Action – Orbital or Straight
(Fig. G)
This jig saw is equipped with four cutting actions, three
orbital and one straight. Orbital action has a more
aggressive blade motion and is designed for cutting in soft
materials like wood or plastic. Orbital action provides a faster
cut, but with a less smooth cut across the material. In orbital
action, the blade moves forward during the cutting stroke in
addition to the up and down motion.
NoTE: Metal or hardwoods should never be cut in
orbital action.
To adjust the cutting action, move the orbital action
lever
8
between the four cutting positions: 0, 1, 2, and 3.
Position 0 is straight cutting. Positions 1, 2, and 3 are orbital
cutting. The aggressiveness of the cut increase as the lever
is adjusted from one to three, with three being the most
aggressive cut.
Fig. G
8
Dust Blower (Fig. H)
The dust blower helps clear the cutting area of debris
created from the blade.
NoTE: When cutting metal, turn the dust blower off so
cutting fluids are not blown away from the blade.
To turn the dust blower on, slide the dust blower control
all the way to the top.
To turn the dust blower off, slide the dust blower control all
the way to the bottom.
Fig. H
Removeable No-Mar Shoe Cover (Fig. I)
The no-mar shoe cover
10
should be used when cutting
surfaces that scratch easily, such as laminate, veneer
or paint.
To attach no-mar shoe cover, place the front of the
aluminum shoe
into the front of the no-mar shoe
7
cover
10
and lower the jig saw. The no-mar shoe will click
securely onto the rear of aluminum shoe.
To remove no-mar shoe cover, grasp the no-mar shoe
cover from the bottom; holding onto the two rear tabs
remove the no-mar shoe cover.
Fig. I
7
10
Anti-Splinter Insert (Fig. J)
NoTE: Do not use the anti-splinter insert with the flush
cutting blade.
The anti-splinter insert
minimize tear-out, especially when cutting veneer, laminate,
or finished surfaces, such as paint. The anti-splinter insert
should be installed into the no-mar shoe cover
no-mar cover is not used, install anti-splinter insert into
shoe
.
7
Fig. J
14
10
OPERATION
9
WARNING: Always observe the safety instructions
and applicable regulations.
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
9
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. K)
NoTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
and firmly pull the battery pack out of the tool
1
handle. Insert it into the charger as described in the charger
section of this manual.
13
14
should be used when trying to
14
2
into the tool handle, align the
ENglish
13
10
. If the
7
33
