DeWalt DCN692M1 Manual De Instrucciones página 16

English
Accessories

WARNING: Since accessories, other than those
offered by D WALT, have not been tested with this
e
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
Recommended accessories for use with your tool
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact D
Tool Co., 701 East Joppa Road, Towson, MD 21286, call
1-800-4-D WALT (1-800-433-9258) or visit our website:
e
www.dewalt.com.
Replacing the Return Springs and Profile

WARNING: For your own safety, read the tool
instruction manual before using any accessory.
Failure to heed these warnings may result in serious
personal injury and damage to the tool and the
accessory. When servicing this tool, use only identical
replacement parts.

CAUTION: If you don't feel comfortable servicing your
tool, take it to a D WALT authorized service center.
e
The user should only attempt to service the springs
and profile. All other service should be completed by
an authorized D WALT service center.
e

CAUTION: Do not lubricate any of the replacement
parts. Lubrication can damage the parts and seriously
affect the life and performance of the tool.
NOTICE: All the mechanical parts of the spring
replacement kit are shown for convenience and
verification of inclusion. The kit also contains a packet
of Loctite adhesive for use in Step 9. Refer to Fig. S.
DCN6901 Return Spring Replacement
Kit (Fig. N–S)
To Change Broken or Worn Return springs
nOTE: Springs should be replaced as a pair, using only the
correct D WALT accessory spring replacement kit.
e
1. Using the key provided, loosen the two screws
11
on either side of the unit. Refer to Figure N.
2. Remove the return system
Figure O.
14
WALT
e
WALT Industrial
e
19
from the unit. Refer to
20
Fig. N
Fig. O
20
3. Slide the spring rail clip 21
Refer to Figure P.
4. Twist and remove the spring bumper
the washer 24 and return spring
Fig. P
Fig. Q
21
22
23
17
5. Mount the new return spring and washer on to the
spring rail . While compressing the spring with the
22
washer near the opposite end of the rail, twist on the
new spring bumper until it is past the groove for the
spring rail clip.
11
19
off of the spring rail 22 .
and remove
23
17 . Refer to Figure Q.
21
23
24