Idiomas disponibles
Idiomas disponibles
Parallel recording
This function allows you to record the same source from a con-
nected device to both TAPE 1 and TAPE 2 simultaneously .
1
Load cassette tapes for recording into both the
TAPE 1 and TAPE 2 compartments.
o If the erasure prevention tabs of the loaded cassette tape
have been broken off, stick a piece of adhesive tape over the
hole(s) .
2
Follow recording procedure steps 2–3 on
pages 18–19 to adjust the recording level.
3
Press the TAPE 1 stop (8 ) button to end
recording standby.
4
Press the PARALLEL REC (parallel recording)
button to start recording.
PARALLEL will appear on the display .
o When using the remote control, press both PARALLEL REC
(parallel recording) buttons on it at the same time .
o Parallel recording cannot be started when paused . Stop the
unit before starting .
o The TAPE 2 REC MUTE (record muting) button can be used to
record silences even during parallel recording (page 20) .
(The TAPE 1 REC MUTE (record muting) button cannot be
used . )
Pausing parallel recording
Press the TAPE 2 PAUSE button .
Press it again to resume parallel recording .
Stopping parallel recording
Press the TAPE 1 or TAPE 2 stop (8) button .
o When source playback stops, recording does not automatically
stop .
24
Recording with a computer
Connect this unit to a computer using a commercially-available USB
cable to convert audio signals from a cassette tape to digital data
and send them to the computer .
Supported operating systems
Computers running the following operating systems can be con-
nected by USB to this unit . Use with operating systems other than
these is not guaranteed (as of November 2017) .
Windows
Windows 7 (32-bit, 64-bit)
Windows 8 (32-bit, 64-bit)
Windows 8 . 1 (32-bit, 64-bit)
Windows 10 (32-bit, 64-bit)
Mac
OS X Lion (10 . 7 )
OS X Mountain Lion (10 . 8 )
OS X Mavericks (10 . 9 )
OS X Yosemite (10 . 1 0)
OS X El Capitan (10 . 1 1)
macOS Sierra (10 . 1 2)
macOS High Sierra (10 . 1 3)
o This unit will run with the standard OS driver, so there is no need
to install a special driver .
