_CF-80_110.book Seite 31 Montag, 20. September 2010 10:40 10
Turning the lid stop around
You can turn the lid stop around if you want to open the lid from the
other side.
To do this, proceed as follows:
Undo the screws on the lock lugs (fig. 5 1, page 4) and take
them off.
Undo the screws on the hinges (fig. 5 2, page 4) and take
them off.
Lay the lid down.
Fit the hinges on the side you want.
Fit the lock lugs on the side you want.
6.2
Energy saving tips
Choose a well ventilated installation location which is protected
from direct sunlight.
Allow hot food to cool down first before you place it into the
device.
Do not open the cooler more often than necessary.
Do not leave the lid open for longer than necessary.
Defrost the cooler once a layer of ice forms.
Avoid unnecessary low temperatures.
6.3
Connecting the cooler
Connecting to a battery (Vehicle or boat)
The cooler can be operated with 12 V or 24 V
Warning – Danger of damaging the device!
e
Disconnect the cooler and other consumer units from the battery
before you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
For safety reasons the cooler is equipped with an electronic system
to prevent the polarity reversal. This protects the cooler against
short-circuiting when connecting to a battery.
Operation
.
g
31