Idiomas disponibles
Idiomas disponibles
How to use your Braun Sensian™ 4
thermometer
Note: The thermometer and Individual should be in the same ambient
temperature for at least 30 minutes.
1 . Power on
Press and release the power button once .
Backlight will come on, the start-up
sequence begins, and a beep will be heard .
If a previous temperature has been taken
the screen will show the last temperature
measured before moving to the ready screen .
If this is the first temperature measurement, a
previous measurement will not display upon
start up .
2 . Ready
When the device is ready three dashed lines will show on
the screen .
3 . Position
Position thermometer 0 .4-2" (1- 5cm)
away from the center of the forehead, just
between the eyebrows .
If the eyebrow area is covered with hair,
sweat or dirt, please clean the area
beforehand to improve the reading
accuracy . It is important to hold the thermometer and the forehead steady
during measurement . Movement will impact the temperature reading .
4 . Take temperature
Press the temperature button to take a measurement . Device will take a
reading and you will hear a beep(s) when reading is complete .
5 . Read temperature
Remove the thermometer and read the
temperature .
Low temperature will display no backlight
color . Normal temperature range will
display a green backlight color and a
single long beep for 0 .4 seconds will be
heard . A fever temperature range will
display a yellow backlight and a single
long beep for 0 .4 seconds will be heard .
6
0.4-2 inches Away
Red
High Fever
Yellow
Fever
Green
Normal
A high fever range will display a red backlight and 10 short beeps will be
heard .
To repeat
Go to step 3 .
6 . To turn off
Press the power button to turn off or the device will also shut off
automatically within 20 seconds of no use . The words OFF will appear on the
LCD screen when it begins to shut down .
How to measure food and liquid temperatures
(non-medical use)
1 . With the thermometer turned on,
press the surface temperature button to
switch from human body temperature
mode to surface temperature mode .
The human temperature icon will
change to the surface temperature
mode icon on the thermometer's display .
2 . Ready
When the device is ready, 3 dashed lines will
appear on the screen .
3 . Position
Position thermometer 0 .4-2" (1- 5cm)
away from food or liquid . Be certain to
not aim at the sides of the container or
bath tub but directly at the food or liquid .
Aiming at the sides of the container will
influence the reading .
Press the temperature button to take a
measurement . Device will take a reading and you will hear a beep when the
reading is complete, unless the sound is set to silent . If the sound is set to
silent you will not hear a beep .
Please note, it is important to keep the thermometer out of the direct line of
steam as this may cause the sensor that takes the temperature reading to
collect condensation and influence the reading .
4 . Read temperature
Remove the thermometer and read the temperature .
Please note the green backlight will be illuminated regardless of the
temperature reading in this mode .
English
7
