Idiomas disponibles
Idiomas disponibles
WHEEL REMOVAL
Refer to the Safety Precautions on page 43.
Front Wheel Removal
1. Raise the front wheel off the ground by
placing a support block under the
engine.
2. Loosen the axle holder nuts (1).
3. Unscrew and remove the front axle shaft
(2). Remove the wheel and side collars.
Do not depress the brake lever when the
wheel is off the motorcycle. The caliper
pistons will be forced out of the cylinders
with subsequent loss of brake fluid. If this
occurs, servicing of the brake system will
be necessary. See your dealer for this
service.
Avoid getting grease, oil, or dirt on the disc
or pad surfaces. Any contamination can
cause poor brake performance or rapid pad
wear after reassembly.
74
(2)
(1) Axle holder nuts
(2) Front axle shaft
(1)
(1)
