Parkside PLEM 50 C4 Instrucciones De Uso página 21

Volume
♦ Press the Function Selection button
symbol
♦ Press the MEAS button
width and height of the volume being measured (see also the
section "Single measurements").
The corresponding line in the volume symbol
individual measured values. Immediately after the third measurement,
the calculated volume is shown in the result line s of the display 1
and the corresponding line of the volume symbol
The length, width and height are shown in sequence in the top three
lines of the display 1.
Single Pythagoras
Pythagoras' Theorem describes the length relationships between the
sides of a right triangle as follows: a² + b² = c², where a and b are
the legs and c is the hypotenuse of the triangle.
Using the "Single Pythagoras" function, it is possible to calculate the
length of one of the legs. This function is particularly useful for hard-
to-reach measurement points.
♦ Press the Function Selection button
single Pythagoras symbol
♦ Press the MEAS button
(largest distance) and one leg (shortest distance to the measured
surface) (see also the section "Single measurements").
│ GB │ IE
■ 18
g appears on the display 1.
r repeatedly to determine the length,
r repeatedly to measure the hypotenuse
e twice until the volume
e three times until the
g appears on the display 1.
g flashes for the
g stops flashing.
PLEM 50 C4