Idiomas disponibles
Idiomas disponibles
6.1
Switching on
5
1. Press the rear section of the on/off switch.
2. Slide the on/off switch forward.
3. Lock the on/off switch.
▶ The motor runs continuously.
6.2
Grinding/polishing
1. Connect the dust extractor to the connector.
2. Lift the grinder clear of the work surface.
3. Use the buttons for speed stages to set the desired speed stage.
▶ Stages 1 and 2 for fine grinding/polishing with fine-grinding pads.
▶ Stages 3 to 6 for grinding/removal of material with diamond cup wheel.
4. Switch the grinder on. → page 27
▶ The grinder is now in continuous operation mode.
CAUTION
Risk of injury due to loss of control! Failure to use both hands to guide the grinder might cause you to lose
control of the grinder and injure yourself.
▶ Always hold the grinder with both hands on the grip and the gripping surface, while moving the grinder
back and forth.
5. Bring the grinder with the accessory tool into full contact with the work surface and keep the tool moving
with a steady back-and-forth action.
6. Apply moderate pressure and do not press the grinder into the material.
6.3
Switching off
7
▶ Press the rear section of the on/off switch.
▶ The on/off switch jumps into the off position and the motor stops.
7
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
•
Carefully remove stubborn dirt.
•
Carefully clean the air vents, if present, with a dry, soft brush.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
•
Use a dry, clean cloth to clean the contacts of the product.
Care of the Liion batteries
•
Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
•
Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels of
moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.
•
Keep the battery free of extraneous oil and grease. Do not permit dust or dirt to accumulate unnecessarily
on the battery. Clean the battery with a dry, soft brush or a clean, dry cloth. Do not use cleaning agents
containing silicone as these can attack the plastic parts.
Do not touch the contacts of the battery and do not remove the factory-applied grease from the contacts.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Maintenance
•
Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
*2359096*
6
2359096
English
27
